REVACRYL X 9045

REVACRYL X 9045 is preserved against bacterial and fungal attack. In the manufacture of finished products, the material has to be retreated, as usual, with suitable biocides to give enhanced preservation.



Technical Informations

Application Advice/Typical Applications


Above the minimum film forming temperature, REVACRYL X 9045 forms a clear, tack-free and water-resistant film which is characterized by good light and ageing resistance. Instruction for use - REVACRYL X 9045 can be diluted with water to provide liquors of any desired concentration. - REVACRYL X 9045 can be thickened by means of thickener emulsions (e. g. ® Rohagit SD 15) and cellulose or starch derivatives. - REVACRYL X 9045 can be applied by the usual methods such as spraying, impregnating, printing, padding and coating. - By mixing REVACRYL X 9045 with other emulsions from the PLEXTOL range, the film properties of the former can be influenced within wide limits and thus adapted to the intended application. - REVACRYL X 9045 is crosslinkable due to the presence of functionalized comonomeres. Applications - REVACRYL X 9045 can be used as cold blend component for foam adhesives and in adhesive compounds based on chloroprene.



Shipping and Storage

Store at an even temperature of between +5°C and +35°C avoiding frost and direct sunlight. Stir product before use. If stored according to these conditions and in the original unopened containers, the dispersion will be stable for 12 months following delivery. Product should be used as soon as possible after opening. During processing, storage and transport, avoid any contact with metals (including non-ferrous metals) which are not protected against corrosion. Detailed information is available on request.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal

For further information regarding this product please refer to:

Dr. Greiner, Katja
Phone: +49(0)2365-49-9816
FAX: +49(0)2365-49-6510
eMail: katja.greiner@synthomer.com


Properties

Character Value Unit
Solids Content 50
pH Value 8,0  
Viscosity <600 mPas 


Available Documents

Technical datasheet


© 2018 Synthomer plc



6