LITEX S 25A10

LITEX S 25A10 is an anionic, waterbased dispersion of a carboxylated styrene butadiene copolymer.



Technical Informations

Application Advice/Typical Applications

The film forming speed makes the latex preferably suitable as a basis for heavy coating systems above 200 µm in thickness dry. The polymer also has good adhesion to polar plastic surfaces. LITEX S 25A10 is also used in 2-component wood adhesives for D4 applications. Above its minimum film formation temperature of approx. + 12°C the dispersion dries up to a transparent, compact odourless film. The dispersion is well compatible with many fillers and pigments. LITEX S 25A10 is used in many applications where a high adhesion to metallic surfaces is required, so as adhesive for the lamination of paper to aluminium foil, either alone or in combination with casein, and also as a binder for paints for the coating of metals like steel, aluminium, zinc.




Shipping and Storage

Store at an even temperature of between +5°C and +35°C avoiding frost and direct sunlight. Stir product before use. If stored according to these conditions and in the original unopened containers, the dispersion will be stable for 12 months following delivery. Product should be used as soon as possible after opening. During processing, storage and transport, avoid any contact with metals (including non-ferrous metals) which are not protected against corrosion. Detailed information is available on request.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

For further information regarding this product please refer to:

Dr. Greiner, Katja
Phone: +49(0)2365-49-9816
FAX: +49(0)2365-49-6510
eMail: katja.greiner@synthomer.com


Properties

Character Value Unit
Solids Content 53.0
pH Value 6,0  
Viscosity < 400 mPas 
Glass Transition Temperature 14 °C 
Minimum film forming temperature (MFFT) 12 °C 
Colour off-white to yellowish white  


Available Documents

Technical datasheet


© 2018 Synthomer plc



6