PLEXTOL R 100

PLEXTOL R 100 is an acrylic copolymer dispersion.



Technical Informations

Application Advice/Typical Applications

For additional information please contact our technical service team.


PLEXTOL R 100 is used in the following applications: Cartridge applied caulks and sealants and flexible fillers As a binder for water based assembly/grab adhesives PLEXTOL R 100 dries to form a flexible, tough film of high water resistance. It can be compounded with fillers and other additives to form coatings for a variety of applications e.g. damp proof membranes, specialist paints and sealants.



Shipping and Storage

This product is supplied in road tankers or in non-returnable plastic drums secured by a lid with clamping ring or in non-returnable palletized bulk containers (net volume 1.000 lt). The product must be protected from frost and exposure to direct sunlight. Storage temperatures between +5 °C and +30 °C are recommended. The product contains in-can preservation to protect it against microbiological attack during transportation. For protection against microbiological contamination during storage stringent plant hygiene is essential. Depending on the storage conditions addition of suitable preservatives may be necessary. Care must be taken that drums and containers are properly closed. During storage, shipping and handling contact with metal surfaces that are not corrosion protected must be avoided. When stored properly, the product has a shelf life of 12 months from the date of delivery.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

For further information regarding this product please refer to:

Fachinger, Thomas
Phone: +49(0)6181-9880094
FAX: +49(0)6181-9880094
eMail: thomas.fachinger@synthomer.com


Properties

Character Value Unit
Glass Transition Temperature (midpoint) 13 °C 
Minimum film forming temperature (MFFT) 0 °C 
Particle Size 0.4 Microns 
pH 6.0  
Specific Gravity (Dispersion) 1.08  
Total Solids 62.0
Viscosity @ 23°C 550 mPa.s 


Available Documents

Technical datasheet


© 2020 Synthomer plc



6