REVERSOL P-9780

Reversol P-9780 is a non-promoted nonthixotropic high heat resistant isophthalic based polyester resin developed to meet the exacting thermal and electrical requirements of the aircraft industry, but is equally suitable for use in other high performance applications where high strength reinforcements such as glass cloth or woven rovings should be used. This resin can be applied by brush or spray equipment and may also be used in the pultrusion process for the production of profile sections. When fully cured and post cured, Reversol P-9780 is resistant to fuel oils and similar chemicals . Fully cured laminates made from Reversol P- 9780 can be exposed for long periods to temperatures up to 150°C, and for shorter periods (several hours) to temperature up to 200°C.

Available Documents

TDS Download

Technical Informations

Application Advice/Typical Applications

(# Curing schedule was 12 hr at 25°C followed by 12hr at 50°C and 3 hr at 80°C, except in determining deflection temperature, where the schedule was 12 hr at 25°C, 12 hr at 50°C, 3 hr at 120°C)

High performance FRP laminates tanks and containers. Pultrusion of profile sections. Glass Flake coating

Shipping and Storage

To ensure maximum stability and maintain optimum resin properties, Reversol P-9780 should be stored in close containers maintained below 32°C and away from heat sources and sunlight. All storage should conform to local fire and building codes. Drums should be stored away from all sources of flame or combustion. Inventory should be maintained at minimum reasonable stock level on first-in-first-out basis. When properly stored, Reversol P-9780 will remain stable for 3 months from date of delivery.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

For further information regarding this product please refer to:

Synthomer Limited Head Office
Phone: +44 (0)1279 436 211
FAX: +44 (0)1279 444 025
eMail: info@synthomer.com


Properties

Character Value Unit
Appearance Straw, clear to semi clear  
Non-Volatile 63 ± 3
Viscosity@ 25 °C - Brookfield #3/60 500 - 750 cps 
Geltime @ 25°C - 100g resin + 1.6 ml cobalt octoate (1%) + 2 ml MEKP 5 - 9 minute 
Acid Value 40 mgKOH/g 
Specific Gravity 1.11  
Volumetric Shrinkage 7.5
Tensile Strength 56 MPa 
Tensile Modulus 5004 MPa 
Elongation at Break 1.6
Flexural Strength 112 MPa 
Flexural Modulus 3925 MPa 
Water Absorption 24 hr at 20ºC 28 mg 
Deflection Temperature (under load 1.80 MPa) 130 °C 
Barcol Hardness (Model GYZJ 934-1) 48  
Refractive Index n20 D 1.554  
Dielectric loss (tan d at 1000 Hz) 0.005  
Dielectric constant (at 10000 Hz) 3.1  


© 2014 Synthomer plc

Home » Markets & Products » Productfinder » Products A-Z » Technical datasheet

  • Paper & Board
  • Construction & Coatings
  • Health & Protection
  • Carpet, Compounds & Foam
  • Functional Polymers
  • Performance Polymers
  • Productfinder
  •     Products A-Z
  •     Products by Specifications