REVERSOL P-9633 V

Reversol P-9633 V is a fast curing, medium viscosity, unsaturated polyester resin designed for hand lamination, but can also be used for machine-run clear sheeting if slight wax content is acceptable. It is slightly waxed, therefore parts exposed to air during fabrication will exhibit slight or no residual tack. This resin is pre-accelerated for ambient temperature cure with addition of Methyl Ethyl Ketone Peroxide (MEKP) as catalyst. Geltime and curing times are sensitive and dependent on the catalyst used, as well as temperature of environment. Generally, use more catalyst on a cold / rainy environment and less on a hot day. Addition of suitable pigment and dye should be done with care depending on clarity / opacity required of finish sheeting.

Available Documents

TDS Download

Technical Informations

Application Advice/Typical Applications

(# Curing schedule was 12hrs at 28°C followed by 12 hrs at 50°C + 3 hrs at 80°C, except for deflection Temperature where the schedule was 12hrs at 28°C followed by 12 hrs at 50°C + 3 hrs at 80°C and 3 hrs at 120°C.)

Clear Roof-sheet fabrication using handlay.

Shipping and Storage

To ensure maximum stability and to maintain optimum resin properties, Reversol P-9633 V should be stored in close containers maintained below 32°C and away from heat sources and sunlight. All storage should conform to local fire and building codes. Drums should be stored away from all sources of flame or combustion. Inventory should be maintained at minimum reasonable stock level and used on a first-in-first-out basis. When properly stored, Reversol P-9633 V will remain stable for 2 months from date of delivery.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

For further information regarding this product please refer to:

Synthomer Limited Head Office
Phone: +44 (0)1279 436 211
FAX: +44 (0)1279 444 025
eMail: info@synthomer.com


Properties

Character Value Unit
Appearance Pinkish clear  
Non-Volatile 63 ± 2
Viscosity@ 25 °C - Brookfield #3/60 320-450 cps 
Geltime @ 25°C -1g MEKP 10-15 minute 
Acid Value 32 mgKOH/g 
Specific Gravity 1.13  
Volumetric Shrinkage 7.3
Curing time -1% MEKP 30 minutes 
Tensile Strength 78.2 MPa 
Tensile Modulus 5077 MPa 
Elongation at Break 2.6
Flexural Strength 129.7 MPa 
Water Absorption 24 hr at 25ºC 18 mg 
Heat Deflection Temperature 70 °C 
Barcol Hardness 44  


© 2014 Synthomer plc

Home » Markets & Products » Productfinder » Products A-Z » Technical datasheet

  • Paper & Board
  • Construction & Coatings
  • Health & Protection
  • Carpet, Compounds & Foam
  • Functional Polymers
  • Performance Polymers
  • Productfinder
  •     Products A-Z
  •     Products by Specifications