REVERSOL P-9509 NW

Reversol P-9509 NW is a variant of Reversol P-9509. It is a non-wax, low reactivity and thixotropic general purpose resin. It is a preaccelerated resin for ambient temperature gel and cure with addition of Methyl Ethyl Ketone Peroxide (MEKP) as catalyst. The resin has outstanding wetting of glass fibre and easy air release during roll down. It is suitable for spray-up and hand lay-up applications. Gel, cure and demoulding time are sensitive and dependent on catalyst used as well as temperature of environment. Generally, use more catalyst on a cold/rainy environment and lesser catalyst on a hot day.

Available Documents

TDS Download

Technical Informations

Application Advice/Typical Applications



Catalysation with 1% MEKP would render resin suitable for general purpose FRP lamination application viz : FRP tank and panel FRP boat fabrication.

Shipping and Storage

To ensure maximum stability and maintain optimum resin properties, Reversol P-9509 NW should be stored in closed containers below 32°C and away from heat sources and sunlight. All storage should conform to local fire and building codes. Drums should be stored away from all sources of flame or combustion. Inventory should be maintained at minimum reasonable stock and used on a first-in-first-out basis. When properly stored, Reversol P-9509 NW will remain stable for 3 months from date of delivery.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

For further information regarding this product please refer to:

Synthomer Limited Head Office
Phone: +44 (0)1279 436 211
FAX: +44 (0)1279 444 025
eMail: info@synthomer.com


Properties

Character Value Unit
Resin Colour Pinkish Opaque  
Non-Volatile 57.5 ± 1.5
Viscosity@ 25°C -Brookfield #3/60 450 – 600 cps 
Thixotropic Index @ 25°C - #3/6 and 60 rpm 1.8 – 3.5  
Geltime @ 25°C - 1% MEKP 25-30 minutes 
Acid Value 40 mgKOH/g 
Specific Gravity 1.12  
Volumetric Shrinkage 7.6
Tensile Strength 62 MPa 
Tensile Elongation 2.2
Heat Distortion Temperature 55
Water Absorption at 23°C 20 mg 
Hardness (Barcol Impressor) 40  


© 2014 Synthomer plc

Home » Markets & Products » Productfinder » Products A-Z » Technical datasheet

  • Paper & Board
  • Construction & Coatings
  • Health & Protection
  • Carpet, Compounds & Foam
  • Functional Polymers
  • Performance Polymers
  • Productfinder
  •     Products A-Z
  •     Products by Specifications