REVERSOL P-780 P

Reversol P-780 PLT is an orthophthalic, flexible, promoted, clear color gelcoat designed for spray application. For normal moulding application, Reversol P- 780 PLT should be controlled to 0.8 – 1.0 mm wet film thickness. Medium reactivity Methyl Ethyl Ketone Peroxide catalyst (MEKP), for example Butanox M-50, at 1 – 2% dosage is recommended for use in tropical condition. Reversol P-780 PLT gelcoat should not be apply at below 15ºC condition. Always homogenize this gelcoat before adding MEKP, by stirring well with hand or with a low shear mixer to avoid aeration, and then allow to stand to regain thixotropy. It is not advisable to add filler into gelcoat because it can adversely affect the properties of gelcoat. Post Curing of GRP articles coated with this gelcoat is recommended before putting these articles into service.

Available Documents

TDS Download

Technical Informations

Application Advice/Typical Applications



Coating for FRP products intended for indoor and non corrosive environment.

Shipping and Storage

To ensure maximum stability and maintain optimum resin properties, Reversol P-780 PLT should be stored in close containers maintained below 32ºC and away from heat sources and sunlight. All storage should conform to local fire and building codes. Inventory should be maintained at minimum reasonable stock and used on a first-in-first-out basis. When properly stored, Reversol P-780 PLT will remain stable for 2 months from date of delivery.

Product Security/Health and Safety

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

Effluents and Pollution Control

Before handling, please read the Safety Data Sheet of this product for advice on safety, use and disposal.

For further information regarding this product please refer to:

Synthomer Limited Head Office
Phone: +44 (0)1279 436 211
FAX: +44 (0)1279 444 025
eMail: info@synthomer.com


Properties

Character Value Unit
Appearance Hazy, very light pinkish gelcoat, free from bits and lumps  
Viscosity@ 25ºC - Brookfield, #5/1 35,000 – 55,000 cps 
Viscosity@ 25ºC - Brookfield, #5/10 5,000 – 7,500 cps 
Thixotropic Index 5.5 minimum  
Geltime @ 25 °C - 100g gelcoat + 2 ml MEKP 10 - 17 minute 
Non-volatile 59 ± 2


© 2014 Synthomer plc

Home » Markets & Products » Productfinder » Products A-Z » Technical datasheet

  • Paper & Board
  • Construction & Coatings
  • Health & Protection
  • Carpet, Compounds & Foam
  • Functional Polymers
  • Performance Polymers
  • Productfinder
  •     Products A-Z
  •     Products by Specifications